Edelbrock Performer RPM E-Tec 435 D.I.Y. Crate Engine Kits


Do-It-Yourself Crate Engine Kits by Edelbrock
 
  • Kit Contents:
  • Thunder Series AVS Electric Choke Carburetor 800 CFM #1813
  • Rollin' Thunder Camshaft #2204
  • RPM Air-Gap Vortec Intake Manifold with Natural Satin Finish #7516
  • Performer RPM E-Tec 170 Cylinder Heads #60975
  • Cylinder Head Bolts #8550
  • 7.191" Push Rod (Set of 16) #9653
  • 1.5:1 Ratio Roller Rocker Arm Kit (Set of 16) #77770
  • Hydraulic Roller Lifters (Set of 16) #97384
  • Lifter Guide and Retainer Plate
  • Timing Chain Cover
  • Crankshaft Balancer
  • Distributor
  • Ignition Coil
  • Oil Filter Adapter, Oil Pump, Oil Pump Shaft, Oil Pump Pickup, Oil Filter and Oil Pan & Gasket
  • Cylinder Head Gaskets, Intake Manifold Gaskets #7235, Valve Cover Gaskets, Fuel Pump Gasket and Timing Cover Gasket
  • Edelbrock Premium SAE 30 Break-In Oil (6 qts.) #1074
  • Torco Engine Assembly Lube #1075
  • Edelbrock Gasgacinch #9300
  • Thread Sealant and Silicone
  • All necessary Hardware and Instructions for Installation
 
Edelbrock is now excited to offer a Do-It-yourself crate engine kit for customers that already have a short-block ready for assembly. These kits for early and late small-block Chevys include Edelbrock camshaft, Edelbrock Thunder Series AVS carburetor, Edelbrock intake manifold, Edelbrock aluminum cylinder heads, Edelbrock roller rocker arms, balancer, oil pump, gaskets, nuts, bolts, assembly lube, break-in oil and detailed assembly instructions. Customers have the choice of a Performer Series package for an 8.5:1 ratio engine or a 9.5:1 ratio for more horsepower and torque.

This Do-It-Yourself crate engine kit will give you everything needed to build your own Edelbrock Performer RPM E-Tec (#45900) crate engine that produces 435 hp and 435 ft-lbs. of torque. It's designed for use with 1987 and later short-blocks with 4-bolt mains, 1-piece rear main seal and camshaft thrust plate.

Application Dyno Emissions Part #
Do-It-Yourself Performer RPM E-Tec 435 Crate Engine Kit 45909
Edelbrock Installation Note INSTALLATION NOTE: This kit does not include: crank shaft, camshaft thrust plate, connecting rods, pistons, rear main seal, freeze plugs, cam bearings, journal bearings, fuel pump, spark plug wires, spark plugs and water pump. Milodon oil pan #31501 supplied with this kit features a right hand dipsticks and will not fit on a 1962-67 Chevy Nova chassis. Flat top pistons are highly recommended in order to maintain the recommended 9.5:1 compression ratio when paired with the supplied Edelbrock 64cc cylinder heads.

Edelbrock Tech Note PRODUCT EMISSIONS GUIDE
The following guide is designed to help you determine which Edelbrock components are legal for use on your vehicle. Learn more about Edelbrock Product Emissions Guide.

    50-State Legal
    For Racing Use ONLY
    For Use on Pre-Pollution Controlled Vehicles (PPCV)
    Stock Replacement Part
    Engine Swaps