Performer RPM SCCA Cylinder Heads For S/B Chevy


Performer RPM SCCA Cylinder Heads for S/B Chevy by Edelbrock
 
  • Cylinder Head Specifications:
  • Combustion chamber volume: 64cc
  • Intake runner volume: 185cc
  • Exhaust runner volume: 65cc
  • Intake valve diameter: 1.94"
  • Exhaust valve diameter: 1.55"
  • Valve stem diameter: 11/32"
  • Valve guides: Manganese bronze
  • Deck thickness: 9/16"
  • Valve spring diameter: Springs NOT Included
  • Valve spring maximum lift: N/A
  • Rocker stud: 3/8"
  • Guideplate: Hardened steel
  • Pushrod diameter: 5/16"
  • Valve angle: 23°
  • Exhaust port location: Stock
  • Spark plug fitment: 14mm x 3/4 reach, gasket seat
 
These heads are designed exclusively for the SCCA American Sedan Series Class. To comply with class rules, there is no blending work in the intake entries, exhaust exits or bowl area of the intake or exhaust. Bare heads will require final sizing of the valve guides and a proper valve job prior to the installation of valves. These heads are engraved with a SCCA approved logo and legal for American Sedan Class. For additional information, please refer to the SCCA rule book. Match with Performer RPM intake, #7101.
  Bare (Single) Complete W/ Valves (Single)
Application Dyno Emissions Satin Satin
Performer RPM SCCA - 608879 608979
Edelbrock Installation Note INSTALLATION NOTE: Match with Edelbrock head gasket sets. Bare heads will have valve guides and seats installed, but will require final sizing and a valve job to match the valves you will be using. To use stock rockers on small-block Chevy heads, .100" longer than stock pushrods are required. Edelbrock pushrods #9629 recommended. Use Head Bolt Kits for easy installation. Recommended spark plugs are Champion RC12YC or equivalent 14mm x 3/4" reach with flat gasket seat. This head does not include valve springs due to the wide variety of camshafts used in competition. Please consult your camshaft manufacturer for appropriate valve spring selection. Deck thickness: 9/16", rocker stud diameter: 3/8", pushrod diameter: 5/16" (width of slot in guide plate).
#608979: Flow Numbers as tested by Edelbrock's SuperFlo SF-1020 flow bench @ 28" H2O
Valve Lift .100" .200" .300" .400" .500" .600" .700"
Intake 61 127 185 217 229 237 -
Exhaust 51 95 118 131 137 140 -
Edelbrock Tech Note TECH NOTE: Please view Cylinder Head Flow Data and Valve Springs & Retainers for all Edelbrock Performance Aluminum Cylinder Heads.
Edelbrock Tech Note PRODUCT EMISSIONS GUIDE
The following guide is designed to help you determine which Edelbrock components are legal for use on your vehicle. Learn more about Edelbrock Product Emissions Guide.

    50-State Legal
    For Racing Use ONLY
    For Use on Pre-Pollution Controlled Vehicles (PPCV)
    Stock Replacement Part
    Engine Swaps