Victor Series Cylinder Heads For B/B Chrysler


Victor Series Cylinder Heads for B/B Chrysler by Edelbrock
 
  • Cylinder Head Specifications:
  • Combustion chamber volume: 72cc
  • Intake runner volume: 280cc /290cc (Raised .650")
  • Exhaust runner volume: 100cc (Raised .250")
  • Intake valve diameter: 2.20"
  • Exhaust valve diameter: 1.81"
  • Valve stem diameter: 11/32"
  • Valve guides: Manganese bronze
  • Deck thickness: 5/8"
  • Valve spring diameter: N/A
  • Valve spring maximum lift: N/A
  • Rocker stud: N/A
  • Guideplate: N/A
  • Pushrod diameter: 3/8"
  • Valve angle: 15°
  • Exhaust port location: Raised .250"
  • Spark plug fitment: 14mm x 3/4 reach, gasket seat
 
    VICTOR B/B CHRYSLER & VICTOR MAX WEDGE FEATURES:
  • The best standard port location head available for competition big-block Chryslers
  • Intake ports are raised .650", exhaust ports are raised .250" for improved flow
  • The intake flange is extended .950" to eliminate the need for intake spacer plates
  • Will fit Edelbrock Victor manifolds for both high and low deck engines
  • Sold without springs or retainers; use recommended springs to match your camshaft
  • Exhaust flange is extended .300" from stock (same as Mopar Stage 6) featuring dry exhaust bolt holes with Heli-Coil® thread inserts
  • Max Wedge intake ports are machined to match intake manifolds for B and RB competition big-block Chryslers
  Bare (Single) Bare W/ Valves (Single)
Application Dyno Emissions Satin Satin
EQUIPPED WITH SPRINGS FOR USE IN HYDRAULIC FLAT TAPPET CAMSHAFT APPLICATIONS
Victor Big-Block Chrysler - 77919 77929
Victor Max Wedge - 77939 77949
Valley cover for RB (413-440, 8.61" wide) - 7798 -
Valley cover for B (383-400, 7.58" wide) - 7799 -
Edelbrock Installation Note INSTALLATION NOTE: For headers, contact TTI (951) 371-4878. Offset intake rockers required, exhaust side accepts standard-spec rockers. May require additional pushrod hole clearance for some combinations. Bare heads will have valve guides & seats installed, but will require final sizing and a valve job to match the valves you will be using. These heads require the use of a 14mm x 3/4" reach, flat gasket spark plug with a heat range appropriate to your application. Deck thickness: 5/8", pushrod diameter: 3/8".
#77929 | #77949: Flow Numbers as tested by Edelbrock's SuperFlo SF-1020 flow bench @ 28" H2O
Valve Lift .100" .200" .300" .400" .500" .600" .700"
Intake 85 150 211 261 298 322 325
Exhaust 63 118 160 189 207 219 226
Edelbrock Tech Note TECH NOTE: Please view Cylinder Head Flow Data and Valve Springs & Retainers for all Edelbrock Performance Aluminum Cylinder Heads.
Edelbrock Tech Note PRODUCT EMISSIONS GUIDE
The following guide is designed to help you determine which Edelbrock components are legal for use on your vehicle. Learn more about Edelbrock Product Emissions Guide.

    50-State Legal
    For Racing Use ONLY
    For Use on Pre-Pollution Controlled Vehicles (PPCV)
    Stock Replacement Part
    Engine Swaps