Edelbrock Performer RPM Series Manifolds For Ford 351C


FORD 351 CLEVELAND V8
PERFORMER RPM E-BOSS 302 (1500-6500 RPM)
With the Performer RPM E-Boss 302 manifold #7129, you can build a mock Boss engine by using a standard 302 block and Edelbrock Performer RPM Cleveland cylinder heads #61699. For high-performance street and competition, our dual-plane design makes outstanding power from 1500 to 6500 rpm. The Cleveland port layout and intake bolt hole pattern fit both 2V and 4V heads. Features include 8.2" deck height, Windsor end rails, water neck and distributor clearance plus front and rear water bosses. Match with an Edelbrock Performer or Thunder Series AVS carburetor. Edelbrock carbs will work with Ford automatic overdrive trans (AOD) when used with Lokar bracket SRK-4000, for more info call (865) 966-2269 or go to www.lokar.com.
Ford 351 Cleveland Performer RPM Series Intake Manifolds by Edelbrock
Application Dyno Emissions Part #
Performer RPM E-Boss 302 Ford Manifold - 7129
Edelbrock Carburetor Recommendation CARB RECOMMENDATIONS: Edelbrock Thunder Series AVS or Performer Series (600-800 cfm) Carburetor.
Edelbrock Installation Note INSTALLATION NOTE: Recommended intake gasket: Edelbrock #7265. Manifold height: A-4.42", B-5.70"; Carb pad height: 5.06". Port exit dimensions: 1.42" x 2.07". For the heights of all Edelbrock manifolds, please visit the the Manifold Reference Dimensions page.

FORD 351 CLEVELAND V8
PERFORMER RPM E-BOSS 351 (1500-6500 RPM)
Build a mock Boss 351 engine with a standard 351W block and Edelbrock Performer RPM Cleveland heads #61699 using the new Performer RPM E-Boss 351 manifold #7183. For both high-performance street and competition, the dual-plane design makes outstanding power from 1500 to 6500 rpm and the Cleveland port layout and intake bolt hole pattern fit both 2V and 4V heads. It features 9.5" deck height, Windsor end rails, water neck and distributor clearance, front and rear water bosses with a standard square bore carburetor pad. Edelbrock carbs will work with Ford automatic overdrive trans (AOD) when used with Lokar bracket SRK-4000, for more info call (865) 966-2269 or go to www.lokar.com.
Ford Performer RPM E-Boss 351 (non-EGR) Intake Manifolds by Edelbrock
Application Dyno Emissions Part #
Performer RPM E-Boss 351 (non-EGR) - 7183
Edelbrock Installation Note CARB RECOMMENDATIONS: Edelbrock Thunder Series AVS or Performer Series (600-800 cfm) Carburetor.
Edelbrock Installation Note INSTALLATION NOTE: Recommended intake gasket: Edelbrock #7265. Manifold height: A-4.42", B-5.70"; Carb pad height: 5.06". Port exit dimensions: 1.42" x 2.07". For the heights of all Edelbrock manifolds, please visit the the Manifold Reference Dimensions page.

Edelbrock Tech Note PRODUCT EMISSIONS GUIDE
The following guide is designed to help you determine which Edelbrock components are legal for use on your vehicle. Learn more about Edelbrock Product Emissions Guide.

    50-State Legal
    For Racing Use ONLY
    For Use on Pre-Pollution Controlled Vehicles (PPCV)
    Stock Replacement Part
    Engine Swaps