Edelbrock Victor Series Manifolds For Ford 5.8L


FORD 5.8L V8
VICTOR FORD 5.8L EFI (4000-7500 RPM)
Designed for 351W based competition engines, the Victor 5.8 EFI manifold is capable of supporting over 700 horsepower. The Victor Ford 5.8L manifold is designed for engine displacements of up to 427 cubic inches. It features our race winning air-gap design which isolates the intake charge from the engine heat that is present in the lifter valley. The manifold's runners have a large cross sectional area of 2.94 square inches which is 54% larger than our #3884 base. The runners feature 1.20" x 2.0" exits and were developed for maximum air flow when used with competition cylinder heads like our Victor Jr. or Victor Ford #77219 heads. The 12.5" runner length is optimized for sustainable power levels up to 7,500 rpm. Accepts 302 Mustang fuel rails with extended crossover. The upper section is powder coated titanium gray. Edelbrock 75mm throttle body is recommended for maximum performance.
Ford 5.8L Victor Series Intake Manifolds by Edelbrock
Application Dyno Emissions Part #
Victor Ford 5.8L (complete, non-EGR) - 3887
Victor Ford 5.8L (base only) - 3886
Victor EFI Upper Plenum Only (includes plenum cover) - 2946
Victor EFI Plenum Cover Only (includes gasket) - 2947
Victor EFI Gasket Set (includes base-to-upper and plenum cover gaskets) - - 7232
Edelbrock Installation Note INSTALLATION NOTE: Recommended intake gasket: Fel-Pro #1262 or #1262R. Port exit dimensions: 1.20" x 2.00". Overall height: 11.58". For the heights of all Edelbrock manifolds, please visit the the Manifold Reference Dimensions page.

Edelbrock Tech Note PRODUCT EMISSIONS GUIDE
The following guide is designed to help you determine which Edelbrock components are legal for use on your vehicle. Learn more about Edelbrock Product Emissions Guide.

    50-State Legal
    For Racing Use ONLY
    For Use on Pre-Pollution Controlled Vehicles (PPCV)
    Stock Replacement Part
    Engine Swaps