Edelbrock Performer Series Manifolds For Holden


HOLDEN 253-304-308 V8
PERFORMER 308 HOLDEN (IDLE-5500 RPM)
Designed for street 253-304-308 c.i.d. Holden V8 engines. This Performer intake manifold is a dual-plane design that is tuned for excellent throttle response from idle to 5500 rpm. The Performer Holden manifold has been designed to fit both cylinder head bolt hole patterns. Pilot holes have been drilled on each side of the exhaust crossover for early or late model cylinder heads and will need to be drilled out depending on application. Will not fit EFI Heads. Accepts both square-bore and spread-bore carbs. Fits Red/Blue/Black engines. Does not have a provision for external heat crossover. Includes Edelbrock square-bore carb adaptor plate #2732, carb gasket and carb studs.
Holden Performer Series Intake Manifolds by Edelbrock
Application Dyno Emissions Satin EnduraShine
Performer Holden (non-EGR) - 2194 21944
Edelbrock Carburetor Recommendation CARB RECOMMENDATIONS: OEM 4-bbl. Edelbrock Thunder Series AVS or Performer Series (600-750 cfm) Carburetor.
Edelbrock Installation Note INSTALLATION NOTE: Do not use high performance or competition type intake gaskets for street application. Due to material deterioration under street driving conditions, internal leakage of both vacuum and oil may occur. Recommended intake gasket: stock gasket set or equivalent. Manifold height: A-3.25", B-4.67"; Carb pad height: 3.96". Port exit dimensions: 1.07" x 1.83". For the heights of all Edelbrock manifolds, please visit the the Manifold Reference Dimensions page.

Edelbrock Tech Note PRODUCT EMISSIONS GUIDE
The following guide is designed to help you determine which Edelbrock components are legal for use on your vehicle. Learn more about Edelbrock Product Emissions Guide.

    50-State Legal
    For Racing Use ONLY
    For Use on Pre-Pollution Controlled Vehicles (PPCV)
    Stock Replacement Part
    Engine Swaps