|
|
| |
Pontiac 326-455 V8
VICTOR PONTIAC EFI (Up to 6500 rpm)
Victor Pontiac EFI is based on the Torker II Pontiac manifold #5056 designed for 1965-79 street 389-455 c.i.d. Pontiac V8s. Can be used with Ram Air IV heads; will not fit Ram Air V heads. Will not fit 265/301 c.i.d. V8s or under Trans Am Shaker hood. Must use Pico style injectors |
 |
| Application |
Part # |
| Victor Pontiac EFI (non-EGR) |
#50565* |
| Victor Pontiac EFI (non-EGR) With Polished Finish |
#505651* |
| Fuel Rail Kit for use with #50565 and Pico style injectors |
#3637 |
| |
| Edelbrock #38783 or #39783.
 Installation Notes: Intake gasket: Edelbrock #7280. HEI will clear. Manifold Height: A-6.03", B-7.15", measured to engine block, .400" higher than stock.
See manifold reference dimensions. Port exit dimensions: 1.03" x 2.03".
|
|
 |
| |
Pontiac 326-455 V8
SUPER VICTOR PONTIAC EFI (Up to 7500 rpm)
Super Victor Pontiac EFI manifolds are based on the Victor Pontiac manifolds #2956 and #2957 for Pontiac 389-455 high performance engines. #29575 uses standard flange, square-bore throttle bodies and #29565 is for 4500 Series throttle bodies. Compatible with standard Pontiac cast iron heads, or use with Edelbrock Performer RPM Pontiac aluminum heads for maximum power. |
 |
| Application |
Part # |
| Super Victor Pontiac EFI (for 4500 Series) |
#29565* |
| Super Victor Pontiac EFI (for standard flange square-bore) |
#29575* |
| Fuel Rail Kit for use with #29565 & #29575 and standard or Pico style injectors |
#3634 |
| |
| Throttle Body Recommendations: Edelbrock #38783 or #39783 for #29575; Edelbrock #38793/39793 or #38883/39883 for #29565.
Installation Notes: Recommended intake gasket: Edelbrock #7280. Manifold Reference Dimensions: R-0.61", F-1.49", W-1.08", H-2.10", CH-7.70", CA-0° for #29565; R-0.61", F-1.49", W-1.08", H-2.10", CH-7.70", CA-0° for 329575.
See manifold reference dimensions. Port exit dimensions: 2.10" x 1.08". |
|
|
| |
Aluminum Fuel Rails
CNC machined from aluminum extrusions, these fuel rails have a 9/16" i.d. fuel passage, a flow-through
design and 3/8" pipe threads on both ends. All hardware is included. Bracket stands included match with
standard injectors (2.650" O-ring spacing) or pico injectors (1.50" O-ring spacing) as indicated. |
 |
| Application |
Part # |
| Fuel Rail Kit for use with #50565 and Pico style injectors |
#3637 |
| Fuel Rail Kit for use with #29565 & #29575 and standard or Pico style injectors |
#3634 |
|
Pro-Flo2 EFI
