302 Ford E-Boss Head Bolt Kit

$245.95

Edelbrock #8562 is a Head Bolt Kit for S/B Ford 302 E-Boss with Edelbrock #61699 cylinder heads on a 8.2" deck (302) block. Includes 7/16" Hex Head Bolts & #9680 Washer/Bushings to use 7/16" bolt in the 1/2" cylinder head bolt holes.

TEMPORARILY OUT OF STOCK

SKU

8562

Details

The Edelbrock #8562 bolt kit contain a complete set of the highest quality head bolts and hardened washers available. Cold-formed to ensure molecular integrity and heat treated prior to thread rolling and machining. Reduced diameter bolt heads eliminate the need for valve train removal to facilitate cylinder head re-torqueing. Hardened and parallel-ground washers are included. Rated at 170,000 p.s.i.

More Information

More Information
Manufacturer	Edelbrock
Application	Application Specific
UPC	00085347085620
Quantity	Kit
Thread Type	Coarse
Thread Diameter	0.4375 in
Minimum Length	4.50 in
Color	Black Oxide
Availability Note	Available to Order
Warranty	12 Months
Emissions Code	N/A
Hazardous Materials Warning	WARNING: This product can expose you to Chromium, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov.
Installation Notes	The Edelbrock #8562 is made specifically for Ford Clevor; Apply oil or suitable thread lubricant to head bolt threads and the underside of bolt heads and washers.; Using the torque sequence (See Figure 1), torque all 7/16" bolts to 65-70 ft./lbs and all 1/2" bolts to 100-110 ft./lbs in four steps (30, 40, 50, 60-75; or 30, 60, 90, 100-110).; Installation is the same as for original equipment cylinder heads. Consult service manual for specific procedures, if necessary.; BOSS 302 CLONE ENGINES - Use Edelbrock Head Bolt Bushings with Integral Washers #9680 in place of washers supplied with your head bolt kit. Torque 7/16" bolts to 65-70 ft./lbs. in four steps (30, 40, 50, 65-70) following the factory tightening sequence. ALL ENGINES - A re-torque is recommended after initial start-up and cool-down (allow 2-3 hours for adequate cooling).
Finish	Black Oxide
Length	(20) 4.50 in
Material	Chromoly