E-Comm Sales: Sales: 888-799-1135 Tech: 800-416-8628 |
FREE Shipping on orders over $50! 0% Financing Available - Learn More
Toggle Nav Toggle Search
Menu
  • Home
  • Big-Block Chrysler Head Bolt Kit

Big-Block Chrysler Head Bolt Kit

main product photo
$200.95
Add to Wish List
Edelbrock #8591 is a Head Bolt Kit for Big-Block Chrysler Engines with Edelbrock 60185, 60189, 60825, 60839, 60917, 60919, 60925, 60929 and 60149 Performer & RPM Cylinder Heads. This kit contains a complete set of Head Bolts & Washers.
In stock
SKU
8591
BUY DIRECT AND GET:
Fast Shipping Fast Shipping
Tech support Tech Support
Easy returns Easy Returns
High-quality High-Quality
Fast Shipping
Fast shipping
We pride ourselves in ensuring all products are shipped as quickly as possible.
Shipping policy
Tech support
Easy returns
We offer a quick and painless return process on all new and unused products when purchased direct.
Return policy
Easy returns
Tech support
Our Tech Support Agents are second to none. We can answer any of your tech inquiries!
Tech support
High-quality
High quality
Our core products are made in the USA offering unsurpassed quality and performance.
About Us

Details

The Edelbrock #8591 bolt kit contain a complete set of the highest quality head bolts and hardened washers available. Cold-formed to ensure molecular integrity and heat treated prior to thread rolling and machining. Reduced diameter bolt heads eliminate the need for valve train removal to facilitate cylinder head re-torqueing. Hardened and parallel-ground washers are included. Rated at 170,000 p.s.i.

REVIEWS

Specs

Manufacturer Edelbrock
Application Application Specific
UPC 00085347085910
Quantity Kit
Thread Type Coarse
Thread Diameter 0.4375 in
Minimum Length 1.75 in
Color Black Oxide
Availability Note Available to Order
Warranty 12 Months
Hazardous Materials Warning WARNING: This product can expose you to Chromium, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov.
Installation Notes
  • The Edelbrock #8591 is made specifically for big block Chrysler; Installation is the same as for original equipment cylinder heads. Consult service manual for specific procedures, if necessary.; Be sure that the surface of the block and the surface of the head are thoroughly cleaned to remove any oily film before installation.; Use alcohol or lacquer thinner on a lint-free rag to clean. Apply oil or suitable thread lubricant to head bolt threads and the underside of bolt heads and washers.; Torque to 70 ft./lbs. in three steps (40, 55, 70) following the factory tightening sequence.; Apply a continuous 1/8" bead of automotive RTV silicone sealer to end sealing surfaces on block and along bottom of intake ports on cylinder head. Also, apply a thin bead of sealer around intake ports on cylinder head and gasket.; Position intake gasket thin valley cover in place and tighten bolts down. Then, place intake manifold in position and torque manifold bolts to 25 ft. lbs.; Rocker shaft hold-down studs, nuts and washers, for 2 places marked (S) in each head, are supplied in this kit.; Double nut both studs and screw them in until they reach the bottom. Install rocker shaft, factory concave washer and hard washer supplied with this kit.; Apply 30W oil to fine threads and under nuts and washers and torque nuts to 25 ft./lbs. A head bolt re-torque is recommended after initial start-up and cool-down (allow 2-3 hours for adequate cooling).
Finish Black Oxide
Head Drive Type Hex
Length (24) 1.75 in, (10) 4.00 in
Material Chromoly