Memorial Day Lunati Valvetrain Sale Shop Now
Torker Holden 253-308 with Red Motor Cylinder Heads

Torker Holden 253-308 w/ Red Motor Cylinder Heads

Big Victor 2 Spread-Port, Tall Deck Intake Manifold for Big-Block Chevy

Big Victor 2 Spread-Port, Tall Deck Intake Manifold for Big-Block Chevy

Big Victor 2 Spread-Port Intake Manifold for Big-Block Chevy

$844.95
Edelbrock Big Victor 2 Spread-Port Intake Manifold for Big-Block Chevrolet
TEMPORARILY OUT OF STOCK
SKU
28001
Edelbrock part #28001 Big Victor 2 Spread-Port intake manifold is designed for large cubic-inch or high rpm drag racing big-blocks with Edelbrock Big Victor, Dart Big Chief or Brodix Big Duke cylinder heads, this manifold has an average runner area of approximately 4.75 sq. in. The port exits have been reduced to accommodate the wide variety of intake port sizes and require port matching. The runners have a minimum corner radius of .500" from the plenum to the exit allowing the popular oval port shape to be used. The outside runners are shorter and straighter than competitor's manifolds and the plenum is longer front to back. These features, combined with approximately 5% taper in runner cross-sectional area, give better top end horsepower while maintaining consistency and throttle response off the stop. All applications are equipped with a 4500 Series flange and will accept 2.25" throttle body butterflies without a spacer or modification.
More Information
Manufacturer Edelbrock
Application Application Specific
UPC 00085347280018
Series Victor
Grade Type Performance
Gasket Or Seal Included No
Vehicle Model Chevrolet
Availability Note Available to Order
Warranty 12 Months
RPM Range 3500-8500 RPM
Emissions Code
Hazardous Materials Warning WARNING: This product can expose you to Lead, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov.
Installation Notes
  • Recommended intake gasket: Fel-Pro #1298.; Manifold height: A-9.21", B-9.21"; Carb recommendations: Use appropriate 4500 Series racing carburetor.; Use RTV sealant to properly seal end seals, such as Edelbrock High Temp Silicone sealant #1076, DO NOT USE END SEALS GASKETS.; Hardened washers Must be used with intake bolts to ensure proper torque and prevent galling of the aluminum.
Color Satin
Finish Satin
Material Aluminum
Rear Maximum Height 9.210 in
Single Or Dual Plane Type Single