Performer Intake Manifold for Holden V8 253-308 CID Engines

$513.95

Edelbrock Performer Intake Manifold for Holden 253-308 c.i.d Engines. Accepts Either OEM 4-bbl or 4150-Style Square-Bore Carburetors.

In stock

SKU

2194

Details

Edelbrock part #2194 Performer intake manifold is designed for street 253-304-308 c.i.d. Holden V8 engines. This Performer intake manifold is a dual-plane design that is tuned for excellent throttle response from idle to 5500 rpm. The Performer Holden manifold has been designed to fit both cylinder head bolt hole patterns. Pilot holes have been drilled on each side of the exhaust crossover for early or late model cylinder heads and will need to be drilled out depending on application. Will not fit EFI Heads (see #7594). Accepts both square-bore and spread-bore carbs. Fits Red/Blue/Black engines. Does not have a provision for external heat crossover. Includes Edelbrock square-bore carb adaptor plate #2732, carb gasket and carb studs.

More Information

More Information
Manufacturer	Edelbrock
Application	Application Specific
UPC	00085347021949
Series	Performer
Grade Type	Performance
Gasket Or Seal Included	No
Vehicle Model	Holden
Availability Note	Available to Order
Warranty	12 Months
Ec Basic Operating Rpm Range	Idle-5500 RPM
Emissions Code
Hazardous Materials Warning	WARNING: This product can expose you to Lead, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov.
Installation Notes	Recommended intake gasket HA265; Do not use high performance or competition type intake gaskets for street application. Due to material deterioration under street driving conditions, internal leakage of both vacuum and oil may occur. Manifold height: A-3.25", B-4.67"; Carb pad height: 3.96"; Carb recommendations: OEM 4-Bbl, Edelbrock AVS2 or Performer Series 600-750 cfm.; Port exit dimensions: 1.07" x 1.83"; Use RTV sealant to properly seal end seals, such as Edelbrock High Temp Silicone sealant #1076, DO NOT USE END SEALS GASKETS. Hardened washers Must be used with intake bolts to ensure proper torque and prevent galling of the aluminum.
Color	Satin
Finish	Satin
Material	Aluminum
Rear Maximum Height	4.670 in
Single Or Dual Plane Type	Dual