Edelbrock E-Series Cylinder Head Bolt Kit #85562 for Pontiac w/Edelbrock heads

$106.95

Edelbrock #85562 is a Head Bolt Kit for 1961-79 Pontiac 326-455 Engines with Edelbrock #6056-6058 Cylinder Heads. Not for Stock Heads.

TEMPORARILY OUT OF STOCK

SKU

85562

Details

Edelbrock E-Series Cylinder Head Bolt Kit #85562 is designed for use on Pontiac engines with Edelbrock Performer and Performer RPM Cylinder Heads #6056-6058. Note that this head bolt kit is required to install these Edelbrock Pontiac heads. The 6056-6058 cylinder heads require a head bolt kit that is similar to that needed for a Ram-Air IV head, which is different from a standard D-port head. Several of the bolt boss heights have been increased to enhance the potential of the heads. E-Series bolts have a yield tensile strength of 190,000 PSI for strong and reliable loading. Bolt threads are rolled after heat-treating for superior form and strength, while a small hex head provides extra space for socket clearance in tight situations. E-Series Cylinder Head Bolts have a durable black oxide finish with sealer and come with the distinctive Edelbrock “E” stamped into the head.

More Information

More Information
Manufacturer	Edelbrock
Application	Application Specific
UPC	00085347855629
Quantity	Kit
Thread Type	Coarse
Thread Diameter	0.50 in
Minimum Length	2.25 in
Availability Note	Available to Order
Warranty	12 Months
Emissions Code	N/A
Features and Benefits	• For use with Performer/Performer RPM heads for Pontiac. • Yield tensile strength of 190,000 PSI. • Heat treating with rolled threads for superior form and strength; black-oxide finish with sealer. • Edelbrock “E” logo stamped on bolt head.
Hazardous Materials Warning	WARNING: This product can expose you to Chromium, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov.
Installation Notes	The Edelbrock #8556 is made specifically for Pontiac V8; Installation is the same as for original equipment cylinder heads. Consult service manual for specific procedures, if necessary.; For 389-455 engines, use Edelbrock #7381, Fel-Pro #1016 or equivalent head gaskets. NOTE: Edelbrock Cylinder Head Gasket Set #7382 may also be used.; This gasket set includes all necessary gaskets for cylinder head installation, including cylinder head, intake, exhaust, water neck and valve cover gaskets.; Be sure that the surface of the block and the surface of the head are thoroughly cleaned to remove any oily film before installation.; Use alcohol or lacquer thinner on a lint-free rag to clean. Coat threads, washers, and underside of bolt heads with motor oil for accurate torque readings.; Torque upper row of bolts to 105 ft. /lbs., torque lower row of bolts to 95 ft./lbs. in three even increments. Start in center and work out towards ends. A re-torque is recommended after initial start-up and cool-down (allow 2-3 hours for adequate cooling).
Finish	Black Oxide
Length	(4) 2.25 in, (4) 4.15 in, (2) 4.25 in, (2) 3.75 in, (4) 4.00 in, (4) 3.00 in
Material	Chromoly