Menu

Edelbrock E-Series Cylinder Head Bolt Kit #85582 for Oldsmobile big-block

$96.95
Add to Wish List
Edelbrock #85582 is a Head Bolt Kit for 1965-76 Oldsmobile 400-425-455 Engines with 60529, 60515, 60519 Cylinder Heads. Complete set of Head Bolts & Washers for a pair of heads.
In stock
SKU
85582
BENEFITS OF BUYING DIRECT FROM EDELBROCK
Fast Shipping Fast Shipping
Tech support Tech Support
Easy returns Easy Returns
High-quality High-quality
Fast Shipping
Fast shipping
Edelbrock prides themselves in ensuring all products are shipped as quickly as possible.
Shipping policy
Tech support
Easy returns
Edelbrock offers a quick and painless return process on all new and unused products.
Return policy
Easy returns
Tech support
Edelbrock Tech Support is second to none. We can answer any of your tech inquiries!
Tech support
High-quality
High quality
Edelbrock core products are made in the USA offering unsurpassed quality and performance.
About Edelbrock

Reviews

No reviews added
Write Your Own Review
You're reviewing:Edelbrock E-Series Cylinder Head Bolt Kit #85582 for Oldsmobile big-block
Your Rating

Details

Edelbrock E-Series Cylinder Head Bolt Kit #85582 is a high-quality replacement bolt set for big-block Oldsmobile engines equipped with Edelbrock Performer RPM cylinder heads. This bolt kit is required when installing Edelbrock heads on an engine previously equipped with cast iron heads. With Edelbrock and other aftermarket aluminum heads, a washer is required which this kit provides along with longer bolts to compensate for the added thickness of the included hardened washers. E-Series bolts have a yield tensile strength of 190,000 PSI for strong and reliable loading. Bolt threads are rolled after heat-treating for superior form and strength, while a small hex head provides extra space for socket clearance in tight situations. E-Series Cylinder Head Bolts have a durable black oxide finish with sealer and come with the distinctive Edelbrock “E” stamped into the head.

Features and Benefits

  • For use with Edelbrock Performer RPM heads on big-block Oldsmobile; Yield tensile strength of 190,000 PSI for strength; Heat treating with rolled threads for superior form and strength; black-oxide finish with sealer

Specs

Availability Available
Application Application Specific
UPC 00085347855827
Quantity Kit
Thread Type Coarse
Thread Diameter 0.4375 in
Availability Note Available to Order
Warranty 12 Months
Hazardous Materials Warning WARNING: This product can expose you to Chromium, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov.
Installation Notes
  • The Edelbrock #8558 is made specifically for Oldsmobile V8; Installation is the same as for original equipment cylinder heads. Consult service manual for specific procedures, if necessary.; Use Edelbrock head gasket #7340 or equivalent. Be sure that the surface of the block and the surface of the head has been thoroughly cleaned to remove any oily film before installation.; Use alcohol or lacquer thinner on a lint-free rag to clean. Coat threads, washers and underside of bolt heads with motor oil or special lube supplied with head bolt kit for accurate torque readings.; Torque 7/16" head bolts to 85 ft.-lbs. If using 1/2" head bolts (which require drilling out the bolt bosses in the heads), torque bolts to 90 ft.-lbs. Torque head bolts in three even increments; Start in the center and work out towards the ends. A re-torque is recommended after initial start-up and cool-down (allow 2-3 hours for adequate cooling).
Finish Black Oxide
Head Drive Type Hex
Length (16) 4.180 in, (4) 3.060 in
Material Chromoly