E-Comm Sales: Sales: 888-799-1135 Tech: 800-416-8628 |
FREE Shipping on orders over $100!
Toggle Nav Toggle Search
Menu

Ford FE Head Bolt Kit

Be the first to review this product
main product photo
$147.95
Add to Wish List
In stock
SKU
8557
BENEFITS OF BUYING DIRECT FROM EDELBROCK
Fast Shipping Fast Shipping
Tech support Tech Support
Easy returns Easy Returns
High-quality High-quality
Fast Shipping
Fast shipping
Edelbrock prides themselves in ensuring all products are shipped as quickly as possible.
Shipping policy
Tech support
Easy returns
Edelbrock offers a quick and painless return process on all new and unused products.
Return policy
Easy returns
Tech support
Edelbrock Tech Support is second to none. We can answer any of your tech inquiries!
Tech support
High-quality
High quality
Edelbrock core products are made in the USA offering unsurpassed quality and performance.
About Edelbrock

Reviews

No reviews added
Write Your Own Review
You're reviewing:Ford FE Head Bolt Kit
Your Rating

Details

The Edelbrock #8557 bolt kit contain a complete set of the highest quality head bolts and hardened washers available. Cold-formed to ensure molecular integrity and heat treated prior to thread rolling and machining. Reduced diameter bolt heads eliminate the need for valve train removal to facilitate cylinder head re-torqueing. Hardened and parallel-ground washers are included. Rated at 170,000 p.s.i.

Specs

Availability Available
Thread Type Coarse
Thread Diameter 0.500 in
Minimum Length 3.750 in
Color Black Oxide
Application Application Specific
UPC 00085347085576
Availability Note Available to Order
Warranty 12 Months
Hazardous Materials Warning WARNING: This product can expose you to Chrome, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov.
Installation Notes
  • The Edelbrock #8557 is made specifically for
  • Installation is the same as for original equipment cylinder heads. Consult service manual for specific procedures, if necessary. Be sure that the surface of the block and the surface of the head are thoroughly cleaned to remove any oily film before installation. Use alcohol or lacquer thinner on a lint-free rag to clean. Apply oil or suitable thread lubricant to head bolt threads and the underside of bolt heads and washers to prevent galling and improper torque readings. Use thread sealant on any bolts that go into coolant passages. Torque top row of bolts to 110 ft./lbs. and bottom row of bolts to 100 ft./lbs. in three or four steps, following the factory tightening sequence. A re-torque is recommended after the initial star-up and cool-down (allow 2-3 hours for adequate cooling)
Finish Black Oxide
Head Drive Type Hex
Length 4.000 in
Material Chromoly