The store will not work correctly in the case when cookies are disabled.
We use cookies to provide you with the best possible user experience. By continuing to use our site, you agree to their use. To learn more, view our
Cookie Policy.
Edelbrock #8558 is a Head Bolt Kit for 1965-76 Oldsmobile 400-425-455 Engines with 60529, 60515, 60519 Cylinder Heads. Complete set of Head Bolts & Washers for a pair of heads.
In stock
SKU
8558
BENEFITS OF BUYING DIRECT FROM EDELBROCK
Fast Shipping
Tech Support
Easy Returns
High-quality
Fast shipping
Edelbrock prides themselves in ensuring all products are
shipped as quickly as possible.
The Edelbrock #8558 bolt kit contain a complete set of the highest quality head bolts and hardened washers available. Cold-formed to ensure molecular integrity and heat treated prior to thread rolling and machining. Reduced diameter bolt heads eliminate the need for valve train removal to facilitate cylinder head re-torqueing. Hardened and parallel-ground washers are included. Rated at 170,000 p.s.i.
Specs
Manufacturer
Edelbrock
Application
Application Specific
UPC
00085347085583
Quantity
Kit
Thread Type
Coarse
Thread Diameter
0.4375 in
Minimum Length
4.000 in
Color
Black Oxide
Availability Note
Available to Order
Warranty
12 Months
Hazardous Materials Warning
WARNING: This product can expose you to Chromium, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov.
Installation Notes
The Edelbrock #8558 is made specifically for Oldsmobile V8; Installation is the same as for original equipment cylinder heads. Consult service manual for specific procedures, if necessary.; Use Edelbrock head gasket #7340 or equivalent. Be sure that the surface of the block and the surface of the head has been thoroughly cleaned to remove any oily film before installation.; Use alcohol or lacquer thinner on a lint-free rag to clean. Coat threads, washers and underside of bolt heads with motor oil or special lube supplied with head bolt kit for accurate torque readings.; Torque 7/16" head bolts to 85 ft.-lbs. If using 1/2" head bolts (which require drilling out the bolt bosses in the heads), torque bolts to 90 ft.-lbs. Torque head bolts in three even increments; Start in the center and work out towards the ends. A re-torque is recommended after initial start-up and cool-down (allow 2-3 hours for adequate cooling).