Performer Intake Manifold for 1985-95 GM 90 Deg V6 (3.8L & 4.3L)

view dyno chart
Special Price $323.06 Regular Price $358.95
Add to Wish List
Performer 4.3L 90 Deg V6 Intake Manifold for 1985-95 Automotive & Marine 200-229-262 c.i.d.(3.8L and 4.3L) GM V6s. Accepts all Marine or Automotive Waternecks, Large/Small Cap HEI & Either 4150-Sytle EPS or Holley's 8007 Carburetor. Non-EGR
In stock
Fast Shipping Fast Shipping
Tech support Tech Support
Easy returns Easy Returns
High-quality High-Quality
Fast Shipping
Fast shipping
We pride ourselves in ensuring all products are shipped as quickly as possible.
Shipping policy
Tech support
Easy returns
We offer a quick and painless return process on all new and unused products when purchased direct.
Return policy
Easy returns
Tech support
Our Tech Support Agents are second to none. We can answer any of your tech inquiries!
Tech support
High quality
Our core products are made in the USA offering unsurpassed quality and performance.
About Us


Edelbrock part #2111 Performer 90 degree V6 intake manifold is designed for street and marine 1985-95 200-229-262 c.i.d. (3.8 and 4.3L) Chevy V6s. Dual bolt pattern water neck fits both automotive and marine applications. Produced 18 more horsepower than an older manifold design on 4.3L marine engine. Will not accept stock automotive carbs or 262 T.B.I. unit.

Documents & Installation Notes



Manufacturer Edelbrock
Application Application Specific
UPC 00085347021116
Series Performer
Gasket Or Seal Included No
Vehicle Model Chevrolet
Availability Note Available to Order
Warranty 12 Months
Ec Basic Operating Rpm Range Idle-5500 RPM
Emissions Code
Hazardous Materials Warning WARNING: This product can expose you to Lead, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit
Installation Notes
  • Recommended intake gasket: Edelbrock #7209 or Fel-Pro #1202; Manifold height: A-3.50", B-4.18"; Carb pad height: 3.84"; Carb recommendations: Edelbrock AVS2 Series or Performer Series 500cfm; Port exit dimensions: 1.15" x 1.87"; Use RTV sealant to properly seal end seals, such as Edelbrock High Temp Silicone sealant #1076, DO NOT USE END SEALS GASKETS.; Hardened washers Must be used with intake bolts to ensure proper torque and prevent galling of the aluminum.
Center Maximum Height 3.840 in
CNC Ported No
Finish Satin
Front Maximum Height 3.500 in
Material Aluminum
Rear Maximum Height 4.180 in
Single Or Dual Plane Type Dual