FREE Shipping on orders over $50*
Performer T.B.I. Intake Manifold Small-Block Chevy

Performer T.B.I. Intake Manifold Small-Block Chevy

Performer Small-Block Oldsmobile 350 EGR Intake Manifold

Performer Small-Block Oldsmobile 350 EGR Intake Manifold

Performer Intake Manifold Small-Block Chevy

$381.95
Edelbrock Performer Intake Manifold For Chevrolet 262-400 Small-Block V8 with1987-1995 Cast Iron Cylinder Heads
In stock
SKU
3706
Edelbrock part #3706 Performer EGR intake manifold is designed for street 262-400 c.i.d. Chevy V8's that have heads with canted center bolt holes, 1987-1995. This intake manifold accepts late-model water neck, air-conditioning, alternator, H.E.I. and have rear water crossovers. For 1987-95 stock aluminum heads use #2101. Will not fit Chevrolet Bowtie or LT1 heads.
More Information
Manufacturer Edelbrock
Application Application Specific
UPC 00085347037063
Series Performer
Material Aluminum
Gasket Or Seal Included No
Vehicle Model Chevrolet
Availability Note Available to Order
Warranty 12 Months
RPM Range Idle-5500 RPM
Emissions Code
Hazardous Materials Warning WARNING: This product can expose you to Lead, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov.
Installation Notes
  • Manifold ht: A-3.50", B-4.60"; Carb pad height: 4.05"; Carb recommendations: OEM 4-Bbl, Edelbrock Performer Series #1400, 600 cfm.; Port exit dimensions: 1.14" x 1.88"; Recommended intake gasket: GM #10163409; Use RTV sealant to properly seal end seals, such as Edelbrock High Temp Silicone sealant #1076, DO NOT USE END SEALS GASKETS.; Sealant must be used on intake bolt threads if the threads extend into lifter valley or coolant passage.; NPT/Pipe thread fittings require the use of Teflon tape or paste on threads to ensure proper seal.; DO NOT OVERTIGHTEN NPT/Pipe fittings, this may cause the aluminum to crack around the fitting boss. NPT/Pipe thread is a tapered thread.; Hardened washers Must be used with intake bolts to ensure proper torque and prevent galling of the aluminum.; Choke plate #8901 included; See adapter #8035 for clamp-on EGR valve.; With carb #1400 & #3701, EGR spacer #1476 is required.; The #3706 has no provision for exhaust heated chokes.; Even though manifolds are compatible with EGR systems, this does not mean they are legal for use on emissions controlled vehicles. Check local laws for legality.; Proper installation is the responsibility of the installer. Improper installation will void your warranty and may result in poor performance and engine or vehicle damage.
Finish Satin
Rear Maximum Height 4.600 in
Single Or Dual Plane Type Dual