FREE Shipping on orders over $50*
Performer-Plus Camshaft Kit for Big-Block Chevy 396-427-454 V8

Performer-Plus Camshaft Kit for Big-Block Chevy 396-427-454 V8

Edelbrock Rollin' Thunder Camshaft Kit for 1987 & Later Small-Block Chevy 383

Edelbrock Rollin' Thunder Camshaft Kit for 1987 & Later Small-Block Chevy 383

Edelbrock Performer-Plus Camshaft Kit for 1957-86 Small-Block Chevrolet

$291.95
Edelbrock Performer-Plus #2117 is designed for 283-400 Chevy V8 engines from 1957-86 and produce optimum torque from the low-end to the mid-range.
In stock
SKU
2117
Edelbrock Performer-Plus Camshaft #2117 is designed for 283-400 Chevy V8 engines from 1957-86 and produce optimum torque from the low-end to the mid-range. Performer-Plus camshafts should be matched with Performer manifolds for vehicles operating from off-idle to 5500 rpm. The Performer-Plus #2117 is a smooth idling cam for daily drivers, trucks, vans, RVs and 4x4s. You can expect a major improvement in throttle response and torque. In the manifold section you'll find torque graphs showing the power gains from Performer manifolds and Performer-Plus cams. All camshafts include flat tappet lifters (except for cams designed for use with stock roller lifters), assembly lube and instructions. This cam produced 338 HP and 389 Ft Lbs of Torque when paired with Performer EPS intake manifold #2701, E-Street cylinder heads #5089 and E-Street EFI system #3664. Camshaft specifications: - Intake duration: 218 Degrees - Exhaust duration: 224 Degrees - Intake lift: .464" - Exhaust lift: .470" - Lobe separation: 114 Degree - Intake Center Line: 110 Degree - Vacuum: 15"
More Information
Manufacturer Edelbrock
Application Application Specific
UPC 00085347021178
Series Performer-Plus
Grade Type Performance
Lifter Materials Hardened Steel
Computer Controlled Compatible No
Intake Duration .050 Inch Lift 218 deg
Availability Note Available to Order
Warranty 12 Months
Emissions Code
Hazardous Materials Warning WARNING: This product can expose you to Chromium, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov.
Installation Notes
  • Recommended Valve Springs for OEM heads: Edelbrock part #5703 non-rotator; In order for this Performer-Plus cam and lifter kit to be covered under ANY WARRANTY you must use either the correct Edelbrock Sure Seat valve springs or the stock original equipment valve springs.; Oil/additive must contain Zinc designed for use with flat tappet camshafts.; Coat cam lobes and bottoms of each lifter with MoS2 lube (supplied) to prevent cam lobe and lifter wear from occurring during initial start-up.; Do not allow the engine to run under 2000 rpm for the first 1/2 hour. Slow idle speeds may result in severe cam and lifter wear. Start the engine and bring to break-in rpm.
Intake Valve Lift 0.464 in
Lifter Type Hydraulic
Lobe Separation 114 deg