Edelbrock Performer-Plus camshaft for Big-Block Chrysler 383-400-440 V-8

$422.95

Edelbrock part #2192 Performer-Plus camshaft is designed for big-block Chrysler 383-400-440 V-8 applications. This Edelbrock cam kit produced 427 ft-lbs. of torque when used with #2191 intake and stock iron cylinder heads on a 440 engine.

TEMPORARILY OUT OF STOCK

SKU

2192

Details

Edelbrock part #2192 Performer-Plus camshaft is designed for 1968 and later big-block Chrysler 383-400-440 V-8 applications. This Edelbrock cam kit produced 427 ft-lbs. of torque when used with #2191 intake and stock iron cylinder heads on a 440 engine. The camshaft will produce optimum torque from the low-end to the mid-range, Performer-Plus camshafts match with Performer manifolds for vehicles operating from off-idle to 5500 rpm. This Performer-Plus is a smooth idling cam for daily drivers, trucks, vans, RVs and 4x4s. You can expect a major improvement in throttle response and torque. All camshafts include flat tappet lifters, assembly lube and instructions. Camshaft Specifications: - Duration @ .050 Intake: 204 degrees - Duration @ .050 Exhaust: 214 degrees - Lift @ Valve Intake: .420" - Lift @ Valve Exhaust: .442" - Lobe Separation: 112 Degrees - Intake Centerline: 107 Degrees - Idle Vacuum @ 1000 RPM's: 14"

PRODUCT SPECS

More Information
Manufacturer	Edelbrock
Application	Application Specific
UPC	00085347021925
Series	Performer-Plus
Grade Type	Performance
Lifter Materials	Hardened Steel
Computer Controlled Compatible	No
Intake Duration .050 Inch Lift	204 deg
Availability Note	Available to Order
Warranty	12 Months
Emissions Code
Hazardous Materials Warning	WARNING: This product can expose you to Chromium, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov.
Installation Notes	Recommended Valve Springs for OEM heads: Edelbrock part #5892 non-rotator/# 5992 Rotator; For 1968 and later.; Camshaft utilizes one bolt configuration.; In order for this Performer-Plus cam and lifter kit to be covered under ANY WARRANTY you must use either the correct Edelbrock Sure Seat valve springs or the stock original equipment valve springs.; Oil/additive must contain Zinc designed for use with flat tappet camshafts.; Coat cam lobes and bottoms of each lifter with MoS2 lube (supplied) to prevent cam lobe and lifter wear from occurring during initial start-up.; Do not allow the engine to run under 2000 rpm for the first 1/2 hour. Slow idle speeds may result in severe cam and lifter wear. Start the engine and bring to break-in rpm.
Advertised Exhaust Duration	280 deg
Advertised Intake Duration	270 deg
Intake Valve Lift	0.420 in
Lifter Type	Hydraulic
Lobe Separation	112 deg