FREE Shipping on orders over $50*
Performer-Plus Camshaft Kit for Small-Block Chevy 283-400 V8

Performer-Plus Camshaft Kit for Small-Block Chevy 283-400 V8

Performer-Plus Camshaft Kit for Big-Block Chevy 396-427-454 V8

Performer-Plus Camshaft Kit for Big-Block Chevy 396-427-454 V8

Performer-Plus Camshaft Kit for Pontiac 350-455 V8

$416.95
Edelbrock part #7157 Performer RPM Camshaft is designed for Pontiac 350-455 V-8 applications. This Edelbrock cam kit produced 422 HP & 441 ft-lbs. of torque when used with #7156 intake and #60599 cylinder heads on a 455 engine.
In stock
SKU
7157
Edelbrock part #7157 Performer RPM Camshaft is designed for Pontiac 350-455 V-8 applications. This Edelbrock cam kit produced 422 HP & 441 ft-lbs. of torque when used with #7156 intake and #60599 cylinder heads on a 455 engine. The camshaft works well with high-performance's street applications, Performer RPM cams provide power from 1500 to 6500 rpm. This hydraulic lifter camshaft is dyno-matched to Performer RPM manifolds for high-rpm horsepower while still maintaining acceptable low-end torque. With 10 to 12 inches of manifold vacuum at idle, Performer RPM cams have more lift and duration than most street camshafts. Hydraulic flat tappet lifters are included with each Performer RPM camshaft. Camshaft Specifications: - Duration @ .050 Intake: 231 degrees - Duration @ .050 Exhaust: 240 degrees - Lift @ Valve Intake: .470" - Lift @ Valve Exhaust: .470" - Lobe Separation: 113.5 Degrees - Intake Centerline: 112 Degrees - Idle Vacuum @ 1000 RPM's: 10"
More Information
Manufacturer Edelbrock
Application Application Specific
UPC 00085347071579
Series Performer-Plus
Grade Type Performance
Lifter Materials Hardened Steel
Computer Controlled Compatible No
Intake Duration .050 Inch Lift 231 deg
Availability Note Available to Order
Warranty 12 Months
Emissions Code
Hazardous Materials Warning WARNING: This product can expose you to Chromium, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov.
Installation Notes
  • Recommended Valve Springs for OEM heads: Edelbrock part #5757; Use only stock ratio rocker arms; Adjustable valvetrain required; In order for this Performer RPM cam and lifter kit to be covered under ANY WARRANTY you MUST use the correct Edelbrock Sure Seat Valve Springs or equivalent.; Do not use rotator type valve springs or retainers for this application.; Oil/additive must contain Zinc designed for use with flat tappet camshafts.; Coat cam lobes and bottoms of each lifter with MoS2 lube (supplied) to prevent cam lobe and lifter wear from occurring during initial start-up.; Do not allow the engine to run under 2000 rpm for the first 1/2 hour. Slow idle speeds may result in severe cam and lifter wear. Start the engine and bring to break-in rpm.
Advertised Exhaust Duration 320 deg
Advertised Intake Duration 308 deg
Intake Valve Lift 0.470 in
Lifter Type Hydraulic
Lobe Separation 114 deg