Performer Rover Intake Manifold for Buick/Olds 215 V-8 Engines

was $410.95 Special Price $369.86

Edelbrock Performer Rover 215 Intake Manifold is designed to fit all Buick and Oldsmobile 215 c.i.d Aluminum V-8 and Rover 3.5L V-8 engines. Accepts 4150-Style Square-Bore Carburetors.

In stock

SKU

2198

Details

Edelbrock part #2198 Performer Rover intake manifold is designed for Rover 3500cc V8's (1968 and later). Manifold also fits 1961-63 Buick and Oldsmobile aluminum 215 c.i.d. V8's. Will not work with stock Stromberg carburetors. Edelbrock's Patented Dual-plane, low-rise design with a 180-degree firing order greatly improves torque over a wide rpm range for excellent throttle response from off-idle through 5500rpm. This Performer intake manifold is ideal for passenger cars, trucks, 4x4s, tow vehicles and RVs.

PRODUCT SPECS

More Information
Manufacturer	Edelbrock
Application	Application Specific
UPC	00085347021987
Series	Performer
Material	Aluminum
Gasket Or Seal Included	No
Vehicle Model	Buick/Rover
Availability Note	Available to Order
Warranty	12 Months
RPM Range	Idle-5500 RPM
Emissions Code
Hazardous Materials Warning	WARNING: This product can expose you to Lead, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov.
Installation Notes	Recommended intake gasket: Fel-Pro #MS96002; Manifold height: A-5.00", B-5.92" measured to engine block; Carb pad height: 5.46"; Carb recommendations: Edelbrock AVS2 or Performer Series 600-800 cfm; Port exit dimensions: .88" x 1.54"; Edelbrock throttle Bracket #8036 will fit; and accepts GM style throttle, kickdown and cruise control cables.; Use RTV sealant to properly seal end seals, such as Edelbrock High Temp Silicone sealant #1076, DO NOT USE END SEALS GASKETS.; Hardened washers Must be used with intake bolts to ensure proper torque and prevent galling of the aluminum.
Finish	Satin
Rear Maximum Height	5.920 in
Single Or Dual Plane Type	Dual