Edelbrock part #7107 RPM Air-Gap LT1 utilizes the proven short runner tunnel-ram style, this manifold provides the next step up in performance for LT1 owners. Our patented Air-Gap design delivers a cooler and denser air stream for maximum power output. This intake manifold is designed to work with either a 52mm throttle body or 58mm throttle body. This manifold also accepts early and late OEM LT1 throttle bodies and fuel rails. #7107 is designed to match #61905/#61919 LT1 cylinder heads.
WARNING: This product can expose you to Lead, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov.
Recommended intake gasket: Edelbrock #7243 or GM #12524653; Manifold height: A-6.00", B-6.00"; Port exit dimensions: A-2.06" x B-1.15"; Performer RPM Air-Gap LT1 intake manifold feature a throttle body pad that will accept OEM and oversized throttle bodies up to 58mm; Use RTV sealant to properly seal end seals, such as Edelbrock High Temp Silicone sealant #1076, DO NOT USE END SEALS GASKETS.; Hardened washers Must be used with intake bolts to ensure proper torque and prevent galling of the aluminum.; Sealant must be used on intake bolt threads if the threads extend into lifter valley or coolant passage.; NPT/Pipe thread fittings require the use of Teflon tape or paste on threads to ensure proper seal.; DO NOT OVERTIGHTEN NPT/Pipe fittings, this may cause the aluminum to crack around the fitting boss. NPT/Pipe thread is a tapered thread.; Carburetor size (CFM) should be selected based on your specific engine combination.; To ensure maximum performance and a proper seal, Edelbrock gaskets which are specifically designed and manufactured for use with Edelbrock parts must be used.; Proper installation is the responsibility of the installer. Improper installation will void your warranty and may result in poor performance and engine or vehicle damage.