Performer RPM II Intake Manifold #7123 For 5.0L Small-Block Ford, Satin Finish

view dyno chart
Add to Wish List
Edelbrock Performer 5.0 RPM II Intake Manifold for Ford 5.0 Small-Block V8
Out of stock
Fast Shipping Fast Shipping
Tech support Tech Support
Easy returns Easy Returns
High-quality High-Quality
Fast Shipping
Fast shipping
We pride ourselves in ensuring all products are shipped as quickly as possible.
Shipping policy
Tech support
Easy returns
We offer a quick and painless return process on all new and unused products when purchased direct.
Return policy
Easy returns
Tech support
Our Tech Support Agents are second to none. We can answer any of your tech inquiries!
Tech support
High quality
Our core products are made in the USA offering unsurpassed quality and performance.
About Us


Edelbrock part #7123 Performer 5.0 RPM II intake manifold for 1986-95 5.0L Mustang engines has shown significant gains in horsepower over existing designs in the 1500 to 6500 rpm range, and is ideally suited for street and strip applications. This manifold consists of a V-shaped crossover with an increasing cross-sectional area, which passes over to eight large tapered runners. Our 70mm throttle body is recommended (75mm will require port matching). 1994-95 Mustang engines require Throttle Body Adapter #38353 and Adapter Kit #8025. May not fit with stock hood of 1994-95 Mustangs, aftermarket hood recommended.

Documents & Installation Notes



Manufacturer Edelbrock
Application Application Specific
UPC 00085347071234
Series Performer RPM
Gasket Or Seal Included No
Vehicle Model Ford
Availability Note Available to Order
Warranty 12 Months
Ec Basic Operating Rpm Range 1500-6500 RPM
Emissions Code
Hazardous Materials Warning WARNING: This product can expose you to Lead, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit
Installation Notes
  • Recommended intake gasket: Edelbrock #7220; Air valve location is 0.30" higher and 0.50" forward from stock; Port exit dimensions: 1.16" x 2.0"; Recommended cams: Ford SVO X-303 or Z-303.; Overall height: 11.13"; Use RTV sealant to properly seal end seals, such as Edelbrock High Temp Silicone sealant #1076, DO NOT USE END SEALS GASKETS.; Hardened washers Must be used with intake bolts to ensure proper torque and prevent galling of the aluminum.
Center Maximum Height 11.130 in
CNC Ported No
Finish Satin
Front Maximum Height 11.130 in
Material Aluminum
Rear Maximum Height 11.130 in
Single Or Dual Plane Type Dual