Performer Small-Block Oldsmobile 350 EGR Intake Manifold

view dyno chart
Add to Wish List
Edelbrock Performer Olds 350 EGR Intake Manifold for Oldsmobile 307-403 Small-Block V8
In stock
Fast Shipping Fast Shipping
Tech support Tech Support
Easy returns Easy Returns
High-quality High-Quality
Fast Shipping
Fast shipping
We pride ourselves in ensuring all products are shipped as quickly as possible.
Shipping policy
Tech support
Easy returns
We offer a quick and painless return process on all new and unused products when purchased direct.
Return policy
Easy returns
Tech support
Our Tech Support Agents are second to none. We can answer any of your tech inquiries!
Tech support
High quality
Our core products are made in the USA offering unsurpassed quality and performance.
About Us


Edelbrock part #3711 Performer Oldsmobile 350 EGR intake manifold is designed for street 307-330-350-403 c.i.d. Oldsmobile V8's, 1964-85. Will fit 1980-1/2 to 1985 307 c.i.d. V8's with 5A heads (casting #3317). This intake manifold comes with a universal pad to fit most carburetors with electric chokes.

Documents & Installation Notes



Manufacturer Edelbrock
Application Application Specific
UPC 00085347037117
Series Performer
Gasket Or Seal Included No
Vehicle Model Oldsmobile
Availability Note Available to Order
Warranty 12 Months
Ec Basic Operating Rpm Range Idle-5500 RPM
Emissions Code
Hazardous Materials Warning WARNING: This product can expose you to Lead, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit
Installation Notes
  • Carb recommendations: OEM 4-Bbl; Edelbrock Performer Series, Thunder Series AVS, AVS2 and Carter AFB carburetors will not fit #3711.; Recommended intake gasket: Fel-Pro #MS96027; For 403 Pontiac Trans Am, use OEM 4-bbl. only (for shaker hood clearance); EGR block-off plate included; Use choke block-off plate #8951 (included); Factory cruise control will not clear EGR valve without linkage alteration.; HEI will clear this manifold; Manifold height: A-2.50", B-3.90"; Carb pad height: 3.20"; Port exit dimensions: 1.18" x 1.86"; Use RTV sealant to properly seal end seals, such as Edelbrock High Temp Silicone sealant #1076, DO NOT USE END SEALS GASKETS.; Hardened washers Must be used with intake bolts to ensure proper torque and prevent galling of the aluminum.
Center Maximum Height 3.200 in
CNC Ported No
Finish Satin
Front Maximum Height 2.500 in
Material Aluminum
Rear Maximum Height 3.900 in
Single Or Dual Plane Type Dual