FREE Shipping on orders over $50*
Edelbrock Chevrolet SBC RPM Manifold With Gaskets, Bolts, Studs, RTV

Edelbrock Chevrolet SBC RPM Manifold w/ Gaskets, Bolts, Studs, RTV

Single-Quad Manifold and carb Kit for 1965-79 Pontiac 389-455

Single-Quad Manifold and carb Kit for 1965-79 Pontiac 389-455

Edelbrock Chevrolet SB RPM Air Gap Manifold w/ Gaskets, Bolts, Studs, RTV

$460.95
Edelbrock Manifold Installation kit PN 2042 includes all the necessary components to replace your existing intake: PN 7501 RPM Air Gap intake manifold, intake gasket set, carburetor base gasket, RTV sealant, intake bolts & carb studs.
In stock
SKU
2042
Edelbrock part #2042 Manifold Installation kit will simplify the process of adding more power and efficiency to your street rod or muscle car. It combines all the necessary components to replace your stock iron intake manifold with an Edelbrock aluminum intake manifold. Kit includes: Performer RPM Air Gap intake manifold #7501, intake gasket set, carburetor base gasket, RTV sealant, intake bolts and carb studs.
** Will not fit under stock Corvette hood! **
More Information
Manufacturer Edelbrock
Application Application Specific
UPC 00085347020423
Vehicle Model Chevrolet
Series RPM Air-Gap
Gasket Or Seal Included Yes
Quantity Kit
Availability Note Available to Order
Warranty 12 Months
RPM Range 1500-6500 RPM
Mounting Hole Quantity (Carb Bolt) 4
Mounting Hole Diameter (Carb Bolt) 5/16-18 UNC in
Angle (Carb) 3 deg
Emissions Code
Hazardous Materials Warning WARNING: This product can expose you to Lead, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov.
Installation Notes
  • Manifold ht: A-4.20", B-5.25" (.70" taller than #2101); Carb pad height: 4.27"; Port exit dimensions: 1.14" x 1.95"; Use RTV sealant to properly seal end seals, such as Edelbrock High Temp Silicone sealant #1076, DO NOT USE END SEALS GASKETS.; Use #8504 Edelbrock bolt kit; Sealant must be used on intake bolt threads if the threads extend into lifter valley or coolant passage.; NPT/Pipe thread fittings require the use of Teflon tape or paste on threads to ensure proper seal.; DO NOT OVERTIGHTEN NPT/Pipe fittings, this may cause the aluminum to crack around the fitting boss. NPT/Pipe thread is a tapered thread.; Hardened washers Must be used with intake bolts to ensure proper torque and prevent galling of the aluminum.; Will not fit under stock Corvette hood.; Proper installation is the responsibility of the installer. Improper installation will void your warranty and may result in poor performance and engine or vehicle damage.
Finish Satin
Material Aluminum
Rear Maximum Height (B) (Measured To Engine Block) 5.25 in
Single Or Dual Plane Type Dual