Free #1221 Air Cleaner With AVS or Performer Carb Purchase Shop Edelbrock
Edelbrock Chevrolet SB Performer EPS Manifold With Gaskets, Bolts, Studs

Edelbrock Chevrolet SB Performer EPS Manifold w/ Gaskets, Bolts, Studs

Edelbrock Chevrolet SB RPM Air Gap Manifold With Gaskets, Bolts, Studs, RTV

Edelbrock Chevrolet SB RPM Air Gap Manifold w/ Gaskets, Bolts, Studs, RTV

Edelbrock Chevrolet SBC RPM Manifold w/ Gaskets, Bolts, Studs, RTV

$378.95
Edelbrock Manifold Installation kit PN 2041 includes all the necessary components to replace your existing intake: PN 7101 Performer RPM intake manifold, intake gasket set, carburetor base gasket, RTV sealant, intake bolts & carb studs.
TEMPORARILY OUT OF STOCK
SKU
2041
Edelbrock part #2041 Manifold Installation kit will simplify the process of adding more power and efficiency to your street rod or muscle car. It combines all the necessary components to replace your intake manifold with an Edelbrock aluminum intake manifold. Kit includes: Performer RPM intake manifold #7101, intake gasket set, carburetor base gasket, RTV sealant, intake bolts and carb studs.
More Information
Manufacturer Edelbrock
Application Application Specific
UPC 00085347020416
Vehicle Model Chevrolet
Series Performer RPM
Gasket Or Seal Included Yes
Quantity Kit
Availability Note Available to Order
Warranty 12 Months
Ec Basic Operating Rpm Range 1500-6500 RPM
Mounting Hole Quantity (Carb Bolt) 4
Mounting Hole Diameter (Carb Bolt) 5/16-18 UNC in
Angle (Carb) 3 deg
Emissions Code
Hazardous Materials Warning WARNING: This product can expose you to Lead, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov.
Installation Notes
  • Manifold ht: A-4.20", B-5.25" (.70" taller than #2101); Carb pad height: 4.27"; Port exit dimensions: 1.16" x 1.92"; Use RTV sealant to properly seal end seals, such as Edelbrock High Temp Silicone sealant #1076, DO NOT USE END SEALS GASKETS.; Use #8504 Edelbrock bolt kit; Sealant must be used on intake bolt threads if the threads extend into lifter valley or coolant passage.; NPT/Pipe thread fittings require the use of Teflon tape or paste on threads to ensure proper seal.; DO NOT OVERTIGHTEN NPT/Pipe fittings, this may cause the aluminum to crack around the fitting boss. NPT/Pipe thread is a tapered thread.; Hardened washers Must be used with intake bolts to ensure proper torque and prevent galling of the aluminum.; Will not fit under stock Corvette hood.; Proper installation is the responsibility of the installer. Improper installation will void your warranty and may result in poor performance and engine or vehicle damage.
Finish Satin
Material Aluminum
Rear Maximum Height (B) (Measured To Engine Block) 5.25 in
Single Or Dual Plane Type Dual