The store will not work correctly in the case when cookies are disabled.
We use cookies to provide you with the best possible user experience. By continuing to use our site, you agree to their use. To learn more, view our
Cookie Policy.
Edelbrock #8556 is a Head Bolt Kit for 1961-79 Pontiac 326-455 Engines with #60575, 60579, 60595, 60599, 61515, 61519, 61525, 61529, 60509, 60569, 60587, & 60589 Edelbrock Cylinder Heads Manufactured before 3/15/02. Not for Stock Heads
The Edelbrock #8556 bolt kit contain a complete set of the highest quality head bolts and hardened washers available. Cold-formed to ensure molecular integrity and heat treated prior to thread rolling and machining. Reduced diameter bolt heads eliminate the need for valve train removal to facilitate cylinder head re-torqueing. Hardened and parallel-ground washers are included. Rated at 170,000 p.s.i.
WARNING: This product can expose you to Chromium, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov.
Installation Notes
The Edelbrock #8556 is made specifically for Pontiac V8; Installation is the same as for original equipment cylinder heads. Consult service manual for specific procedures, if necessary.; For 389-455 engines, use Edelbrock #7381, Fel-Pro #1016 or equivalent head gaskets. NOTE: Edelbrock Cylinder Head Gasket Set #7382 may also be used.; This gasket set includes all necessary gaskets for cylinder head installation, including cylinder head, intake, exhaust, water neck and valve cover gaskets.; Be sure that the surface of the block and the surface of the head are thoroughly cleaned to remove any oily film before installation.; Use alcohol or lacquer thinner on a lint-free rag to clean. Coat threads, washers, and underside of bolt heads with motor oil for accurate torque readings.; Torque upper row of bolts to 105 ft. /lbs., torque lower row of bolts to 95 ft./lbs. in three even increments. Start in center and work out towards ends. A re-torque is recommended after initial start-up and cool-down (allow 2-3 hours for adequate cooling).
Finish
Black Oxide
Length
(4) 2.25 in, (4) 4.15 in, (2) 4.25 in, (2) 3.75 in, (4) 4.00 in, (4) 3.00 in