Menu

Spider Intake for #2950 SBC Manifold

$312.44
Add to Wish List
In stock
SKU
2958
BENEFITS OF BUYING DIRECT FROM EDELBROCK
Fast Shipping Fast Shipping
Tech support Tech Support
Easy returns Easy Returns
High-quality High-quality
Fast Shipping
Fast shipping
Edelbrock prides themselves in ensuring all products are shipped as quickly as possible.
Shipping policy
Tech support
Easy returns
Edelbrock offers a quick and painless return process on all new and unused products.
Return policy
Easy returns
Tech support
Edelbrock Tech Support is second to none. We can answer any of your tech inquiries!
Tech support
High-quality
High quality
Edelbrock core products are made in the USA offering unsurpassed quality and performance.
About Edelbrock

Reviews

No reviews added
Write Your Own Review
You're reviewing:Spider Intake for #2950 SBC Manifold
Your Rating

Details

The Edelbrock Victor 18 degree #2958 Spider intake manifold features intake runners with a large cross-section area of 3.2 square-inches for max high-end horsepower in engines operating from 5000 to 8500 rpm with GM or Edelbrock 18 degree heads. Features 1/2" female pipe bosses over rear water outlets to allow for customization of cooling system and dual distributor clamp locations for ease of timing adjustment. Relief for center water outlets included. The Spider is part of a two-piece design and can be used with Edelbrock base plate #2992. The Edelbrock Victor 18 degree #2958 is a single-plane, high-rise intake designed for maximum race-winning power at higher engine speeds

Specs

Availability Available
Application Application Specific
UPC 00085347029587
Availability Note Available Only While Supplies Last
Warranty 12 Months
Hazardous Materials Warning WARNING: This product can expose you to Lead, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov.
Installation Notes
  • Recommended Intake Gasket: Fel-Pro #1282
  • Use RTV sealant to properly seal end seals, such as Edelbrock High Temp Silicone sealant #1076, DO NOT USE END SEALS GASKETS.
  • Hardened washers Must be used with intake bolts to ensure proper torque and prevent galling of the aluminum.