Super Victor 23 Degree Small Block Chevy Endurashine Intake Manifold

Add to Wish List
Edelbrock Super Victor 23 Degree Intake Manifold for Chevrolet 262-400 Small-Block V8
Out of stock
Fast Shipping Fast Shipping
Tech support Tech Support
Easy returns Easy Returns
High-quality High-quality
Fast Shipping
Fast shipping
Edelbrock prides themselves in ensuring all products are shipped as quickly as possible.
Shipping policy
Tech support
Easy returns
Edelbrock offers a quick and painless return process on all new and unused products.
Return policy
Easy returns
Tech support
Edelbrock Tech Support is second to none. We can answer any of your tech inquiries!
Tech support
High quality
Edelbrock core products are made in the USA offering unsurpassed quality and performance.
About Edelbrock


No reviews added
Write Your Own Review
You're reviewing:Super Victor 23 Degree Small Block Chevy Endurashine Intake Manifold
Your Rating


Edelbrock part #29254 Super Victor 23 degree intake manifold is designed for use with small-block Chevy cylinder heads with a standard port location. Its runners match the "flat floor" entry of the latest 23 degree cylinder heads. Carb pad height is 5-1/2" (from end seals) and overall, the #29254 is about one-inch taller than our Victor Jr. intake #2975. Runners have a 2.80 square-inch cross-section.


Availability Available
Application Application Specific
UPC 00085347292547
Series Victor
Gasket Or Seal Included No
Vehicle Model Chevrolet
Availability Note Available Only While Supplies Last
Warranty 12 Months
Ec Basic Operating Rpm Range 3500-8000 RPM
Emissions Code
Hazardous Materials Warning WARNING: This product can expose you to Lead, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit
Installation Notes
  • Recommended intake gasket: Edelbrock #7201; Carb recommendations: use appropriate standard flange square-bore racing carb.; No provisions for exhaust heated chokes or EGR.; Use RTV sealant to properly seal end seals, such as Edelbrock High Temp Silicone sealant #1076, DO NOT USE END SEALS GASKETS.; Optimum cylinder head port opening size should be as close as possible to the size of the gasket being used.; Hardened washers Must be used with intake bolts to ensure proper torque and prevent galling of the aluminum.; Sealant must be used on intake bolt threads if the threads extend into lifter valley or coolant passage.; NPT/Pipe thread fittings require the use of Teflon tape or paste on threads to ensure proper seal.; To ensure maximum performance and a proper seal, Edelbrock gaskets which are specifically designed and manufactured for use with Edelbrock parts must be used.
Center Maximum Height 5.500 in
CNC Ported No
Finish EnduraShine
Front Maximum Height 5.500 in
Material Aluminum
Rear Maximum Height 5.500 in
Single Or Dual Plane Type Single