Free #1221 Air Cleaner With AVS or Performer Carb Purchase Shop Edelbrock
Performer EPS Vortec Intake Manifold for Small-Block Chevy, Black Finish

Performer EPS Vortec Intake Manifold for Small-Block Chevy, Black Finish

Big Victor 2 Spread-Port Intake Manifold for Big-Block Chevy

Big Victor 2 Spread-Port Intake Manifold for Big-Block Chevy

Torker Holden 253-308 w/ Red Motor Cylinder Heads

$535.95
Edelbrock Torker 308 Intake Manifold for Small-Block Holden Engines is Designed for 253-304-308 C.I.D. V8's with Red Motor Cylinder Heads. Will Not Fit Black/Blue Cylinder Heads. Accepts a 4150-Style Square-Bore Carburetor. Non-EGR.
Availability: In stock
SKU
2790
Edelbrock part #2790 Torker 308 intake manifold is designed for Holden 253-304-308 c.i.d. V8 engines with Red motor cylinder heads only (with single bolt in center of manifold), will not fit on Blue/Black cylinder head engines. The Torker 308 intake manifold is a single-plane design and is recommended for street high performance and race engines operating between the 2500 to 6500 rpm range where low-end torque is not required. Accepts square-bore carbs only.
More Information
Manufacturer Edelbrock
Application Application Specific
UPC 00085347027903
Series Torker/Torker II
Grade Type Performance
Gasket Or Seal Included No
Vehicle Model Holden
Availability Note Available to Order
Warranty 12 Months
Ec Basic Operating Rpm Range 2500-6500 RPM
Emissions Code
Hazardous Materials Warning WARNING: This product can expose you to Lead, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov.
Installation Notes
  • Do not use competition style intake gaskets for this street manifold. Due to material deterioration over time, internal leakage of vacuum, oil, and coolant may occur.; Recommended intake gasketHA265; Manifold height: A-2.95", B-4.50"; Carb pad height: 3.73"; Carb recommendations: OEM 4-Bbl, Edelbrock AVS2 or Performer Series 600-650 cfm; Port exit dimensions: 1.03" x 1.88"; Use RTV sealant to properly seal end seals, such as Edelbrock High Temp Silicone sealant #1076, DO NOT USE END SEALS GASKETS.; Hardened washers Must be used with intake bolts to ensure proper torque and prevent galling of the aluminum.
Color Satin
Finish Satin
Material Aluminum
Rear Maximum Height 4.500 in
Single Or Dual Plane Type Single