The store will not work correctly when cookies are disabled.
We use cookies to provide you with the best possible user experience. By continuing to use our site, you agree to their use. To learn more, view our
Cookie Policy.
Edelbrock part #5056 Torker II Pontiac intake manifold is designed for 1965-79 street 389-455 c.i.d. Pontiac V8's. Can be used with Ram Air IV heads. Will not fit Ram Air V and 265/301 V8's or under Trans Am Shaker hood.
WARNING: This product can expose you to Lead, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov.
Installation Notes
Recommended intake gasket: Edelbrock #7280; No provisions for OEM choke; OEM carb requires conversion to electric/manual choke; For 1968-71 use Edelbrock #8015 throttle bracket; Manifold height: .400" taller than stock, A-6.03", B-7.15 measured to engine block; Carb pad height: 6.59"; Carb recommendations: Edelbrock AVS2 or Performer Series 750-800 cfm.; Port exit dimensions: 1.10" x 2.06"; Use RTV sealant to properly seal end seals, such as Edelbrock High Temp Silicone sealant #1076, DO NOT USE END SEALS GASKETS.; Hardened washers Must be used with intake bolts to ensure proper torque and prevent galling of the aluminum.
WARNING: This product can expose you to Lead, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov. 
