FREE Shipping on orders over $50*
Victor Jr Small Block Chevy LS3/L92/L76 Intake Manifold Carburetor

Victor Jr Small Block Chevy LS3/L92/L76 Intake Manifold Carburetor

Victor 383 Intake Manifold Chrysler B Block

Victor 383 Intake Manifold Chrysler B Block

Victor 15-18 Degree Intake Manifold Small-Block Chevy

$628.95
Edelbrock Victor 15-18 Degree Intake Manifold For 15 and 18 Degree Chevy for 4500 Series Carburetors
In stock
SKU
2859
Edelbrock part #2859 Victor Glidden intake manifold is for all-out nitrous-assisted drag race applications. Designed with noted drag racer Billy Glidden, it features intake runners with a large cross-section area of 3.2 square-inches for maximum high-end horsepower in engines operating from 5000 to 8500 rpm with GM or Edelbrock 18-degree heads. Carb mount flange and plenum are machined for 4500 Series carburetors and require port matching and blending prior to use. The Edelbrock Victor Glidden is a single-plane, high-rise intake designed for maximum race-winning power at higher engine speeds.
More Information
Manufacturer Edelbrock
Application Application Specific
UPC 00085347028597
Series Victor
Material Aluminum
Gasket Or Seal Included No
Vehicle Model Chevrolet
Availability Note Available to Order
Warranty 12 Months
RPM Range 5000-8500 RPM
Emissions Code
Hazardous Materials Warning WARNING: This product can expose you to Lead, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov.
Installation Notes
  • Recommended intake gasket: Edelbrock #7218 or Fel-Pro #1282; Carb Pad Height: 7.03"; For use with 15 and 18 Degree Chevy with 4500 Series Carburetor.; Use RTV sealant to properly seal end seals, such as Edelbrock High Temp Silicone sealant #1076, DO NOT USE END SEALS GASKETS.; Optimum cylinder head port opening size should be as close as possible to the size of the gasket being used.; Hardened washers Must be used with intake bolts to ensure proper torque and prevent galling of the aluminum.; Sealant must be used on intake bolt threads if the threads extend into lifter valley or coolant passage.; NPT/Pipe thread fittings require the use of Teflon tape or paste on threads to ensure proper seal.; Proper installation is the responsibility of the installer. Improper installation will void your warranty and may result in poor performance and engine or vehicle damage.
Finish Satin
Rear Maximum Height 7.030 in
Single Or Dual Plane Type Single