Victor Ram 23-Degree Intake Manifold Base for Small-Block Chevy

Add to Wish List
Edelbrock Victor Ram 23 Degree Intake Manifold Base For Chevrolet 262-400 Small-Block V8
Out of stock
Fast Shipping Fast Shipping
Tech support Tech Support
Easy returns Easy Returns
High-quality High-Quality
Fast Shipping
Fast shipping
We pride ourselves in ensuring all products are shipped as quickly as possible.
Shipping policy
Tech support
Easy returns
We offer a quick and painless return process on all new and unused products when purchased direct.
Return policy
Easy returns
Tech support
Our Tech Support Agents are second to none. We can answer any of your tech inquiries!
Tech support
High quality
Our core products are made in the USA offering unsurpassed quality and performance.
About Us


Edelbrock part #7070 Victor Ram 23-degree for Small-Block Chevy is a tunnel ram manifold base for the control of high velocity mixture flow, especially above 8500 rpm. Suited to drag race engines operating at 6500-10,000 rpm and race boat engines above 7000 rpm. Does not fit raised port cylinder heads or 1987 and later cast iron heads.



Manufacturer Edelbrock
Application Application Specific
UPC 00085347070701
Series Dual-Quad/Multi Carb
Grade Type Performance
Gasket Or Seal Included No
Vehicle Model Chevrolet
Availability Note Available to Order
Warranty 12 Months
Ec Basic Operating Rpm Range 6500-10000 RPM
Hazardous Materials Warning WARNING: This product can expose you to Lead, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit
Installation Notes
  • Recommended intake gasket: Fel-Pro #1206; Distance from carburetor center to carburetor center: 8.88"; Manifold top with base height: 9.25"; H.E.I. ignition will not clear manifold; For the heights of all Edelbrock manifolds, please visit the Manifold Reference Dimensions page.; H.E.I. ignition will not clear manifold; Base ONL:Y; Match with Edelbrock top #7073; Use RTV sealant to properly seal end seals, such as Edelbrock High Temp Silicone sealant #1076, DO NOT USE END SEALS GASKETS.; Optimum cylinder head port opening size should be as close as possible to the size of the gasket being used.; Hardened washers Must be used with intake bolts to ensure proper torque and prevent galling of the aluminum.; Sealant must be used on intake bolt threads if the threads extend into lifter valley or coolant passage.; NPT/Pipe thread fittings require the use of Teflon tape or paste on threads to ensure proper seal.
Center Maximum Height 7.130 in
CNC Ported No
Front Maximum Height 7.130 in
Material Aluminum
Rear Maximum Height 7.130 in
Single Or Dual Plane Type Single